 |
|||||
|
Installation
Bartlett Gutter Company uses a with screws installed approximately every two feet.
Most competitors use (nails) and spacing them approximately three to four feet apart. This often causes the nails to back out of the face of the gutter allowing the gutter to pull away from the house.
Bartlett Gutter Company uses a high performance Terpolymer Sealant on all miters and end caps. This provides a watertight seal and will allow for expansion of the metal. Other competitors may use a gutter lap sealant that often becomes hard and brittle causing leaks to occur.
Bartlett Gutter Company uses stamped strip miters on all corners that allows for the expansion of the metals and does not cause the gutter to pull apart at the corners.
come in various sizes:
2 x 3 inch, 3 x 4 inch and 4 x 5 inch are all available. The most commonly used size is the 3 x4 inch downspout for both 5 and 6 inch gutters.
|